Need Fiberspar 150-188 cm carbon boom end

[pe4387]

My boom broke right at the clew clamp.....bridge that boom clamp is attached too. Thought I'd take a chance and ask if someone has broken boom but carbon end piece is good.

Trying to repair it. Routed out soft insides and attempting expoxy fiberglass plug inside both ends of the bridge wiith original boom outhaul clamp. Maybe. Only use it for beginners in general.

[kevinkan]

there used to be an HPL part that was a carbon tail bridge w/ pulleys... we used to take these old Fiberspar tails, remove the tubes and epoxy them into this bridge... took a little bit of elbow grease, but it worked. HPL later used this part on it's carbon slalom and race booms.

Looked like this (w/o the added white plastic parts):

http://www.calema.com/forums/articles/outhaulpulley.jpg

maybe you could find one of these? I'll check around for you to see if somebody has one laying around unused.