myiW Current Conditions and Forecasts Community Forums Buy and Sell Services
 
Hi guest · myAccount · Log in
 SearchSearch   ProfileProfile   Log in to check your private messagesLog in to check your private messages   RegisterRegister 
Board repair - place your bets on whether this will work
Goto page Previous  1, 2, 3
 
Post new topic   Reply to topic    iWindsurf Community Forum Index -> Windsurfing Discussion
View previous topic :: View next topic  
Author Message
U2U2U2



Joined: 06 Jul 2001
Posts: 5467
Location: Shipsterns Bluff, Tasmania. Colorado

PostPosted: Thu Aug 22, 2013 5:32 pm    Post subject: Reply with quote

If I were to overlay it would be 1st carbon
Then fiberglass. Paint then anti skid

Won't last forever , how long is a wag

_________________
K4 fins
4Boards....May the fours be with you

http://www.k4fins.com/fins.html
http://4boards.co.uk/
Back to top
View user's profile Send private message
Jim.od3



Joined: 25 Aug 2012
Posts: 90

PostPosted: Tue Jul 14, 2020 7:38 pm    Post subject: Reply with quote

Well, it's coming up on 7 years since I repaired the soft spot on the Mistral Flow, and I am here to report the final results . . .
I'm guessing I've had 15 or so sessions on the board since the repair. The soft spot started to redevelop about two seasons ago. It's still much smaller than pre-repair, but noticeable and growing. Since then I have acquired some new boards in the 100L+ range that I am riding more often, but I still like the Flow just fine. I will continue to use it once in a while until it fails.

I think most of the original comments on the repair were along the lines that it will probably last 10+ sessions and the soft spot will eventually return, which is exactly what happened. So good on y'all.

-Jim
p.s. no big jumps with hard landings in all those 7 years. . . not that I didn't try.
Back to top
View user's profile Send private message
isobars



Joined: 12 Dec 1999
Posts: 20935

PostPosted: Tue Jul 14, 2020 10:20 pm    Post subject: Reply with quote

1. Dress for the swim.

2. Pray for a swap meet.

3. I once hand-fitted and laid a thin sheet of stainless steel over a soft spot like that beneath one back heel, then put a pad over it. Very easy, cheap, and felt fine for years. It apparently had just enough flex to keep from concentrating all the forces to its edges.

4. I press and bang on the deck between the straps, and open-hand-slap the whole bottom (listening and looking for delam) of every used board I buy.
Back to top
View user's profile Send private message
U2U2U2



Joined: 06 Jul 2001
Posts: 5467
Location: Shipsterns Bluff, Tasmania. Colorado

PostPosted: Wed Jul 15, 2020 8:03 am    Post subject: Reply with quote

Thanks for the update.
I use the West Systems product, but never like that. My repair would have been a lot more extensive. But then..
The effort and amount spend and time in this case seems to have been worth it.

_________________
K4 fins
4Boards....May the fours be with you

http://www.k4fins.com/fins.html
http://4boards.co.uk/
Back to top
View user's profile Send private message
swchandler



Joined: 08 Nov 1993
Posts: 10588

PostPosted: Wed Jul 15, 2020 11:19 am    Post subject: Reply with quote

I wouldn't worry too much about breaking the board jumping, because you are always in the straps while jumping. Soft spots are generally caused by foot placement in the area in front of the back strap during jibes. If the bottom of the board is still sound you're pretty good to go.

One way to discern the integrity of the bottom is the coin test. Take a quarter edgewise between your thumb and index finger and tap it repeatedly in the footstrap areas and in between. For a contrast, compare the sound to the bottom of the board in the nose area. If the you find a deadened sound in the footstrap areas, that is a sign that the bottom is fatigued and could be suspect over time.
Back to top
View user's profile Send private message
Jim.od3



Joined: 25 Aug 2012
Posts: 90

PostPosted: Wed Jul 15, 2020 12:36 pm    Post subject: Reply with quote

I definitely have a better idea of problems to look for in future used board purchases - that knowledge alone is worth the repair effort to me.
Thanks for all the input.
-Jim
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    iWindsurf Community Forum Index -> Windsurfing Discussion All times are GMT - 5 Hours
Goto page Previous  1, 2, 3
Page 3 of 3

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum

myiW | Weather | Community | Membership | Support | Log in
like us on facebook
© Copyright 1999-2007 WeatherFlow, Inc Contact Us Ad Marketplace

Powered by phpBB © 2001, 2005 phpBB Group